In case you're wondering why I haven't covered the Prusa Core One L yet: Well, I was planning to go to the launch, but Covid finally got me after all this time. Those were two horrible weeks of my life that I'll never get back, and I'm still not back to 100% on stamina and smell.

Praise our lord and savior, the 57mm hole saw www.youtube.com/watch?v=ik9y...

BLDC servos are smaller and more powerful than steppers - then why aren't we using them everywhere?

It's not the stiffness that matters, it's how you use it www.youtube.com/watch?v=pC33...

Relationship status: It's complicated 💀 www.youtube.com/watch?v=30gz...

Big printer. Very impressive. www.youtube.com/watch?v=sbL5...

Yes, I'm still alive (and the cake was fantastic)! Meet Caroline, my experimental low-cost robot arm - swinging a camera today, on the way to running my Studio tomorrow. www.youtube.com/watch?v=rKyJ...

If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉 (Creator Museum is to the right as you walk into the main stage building)

If you're at Open Sauce tomorrow, do check out Caroline - she'll be hanging out in the far corner of the Creator Museum, ready to give you some side-eye 😉 (Creator Museum is to the right as you walk into the main stage building)

Found some lovely people at Open Sauce that could give my little robot project a ride to the creator museum 🤩

Ready for packaging (minus a few details) Let's hope she survives the flight!

Basically, a modern-day Ender-3 youtu.be/xjQzALNuwCM

I'm building a little something to bring to OpenSauce 🍰

Handle secured.